SMR Gearbox Installation
Satisfactory effectiveness is determined by proper installation. lubrication and upkeep. for that reason it’s important the directions during the set up and upkeep leaflet. supplied with every single gearbox. are followed very carefully. a few of the critical facets of belt and torque-arm set up are listed beneath.
1. Install pulley on gearbox input shaft as close for the reducer probable, and mount reducer on driven shaft as close to bearing as sensible. failure to do this may trigger excess loads from the input shaft bearings and output bearings and could lead to their premature failure.
2. Install motor and wedge belt drive using the belt pull at about 90° on the center line between driven and input shafts. this can permit tensioning of the wedge belt drive with the torque arm which ought to preferably be in stress. if output hub runs anti-clockwise. torque arm should be positioned the right.
3. lnstall torque-arm fulcrum on a rigid support to ensure the torque-arm will probably be at around ideal angles towards the center line through the driven shaft as well as torque arm situation bolt. ensure that there exists ample get up while in the turnbuckle for belt tension adjustment.
Hold close.
Bell drive could be situated in any easy postion. if your torque arm will be to be utilised to tighten the belts, the drive should be at about tight angle for the line in between the input and output shafts.
Bell drive may very well be positioned on the right if wanted.
If output hub rotates clock-wise. place belt drive and torque arm in opposite course to that shown while in the illustration.
Torque arm and belt get up.
Torque arm could possibly be mounted towards the ideal if preferred.