Energy UNITS FOR LIFT TABLE one
Basic Description
This electrical power unit is built exclusively to the smaller lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit has become widely utilised during the field of logistic units like minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled from the solenoid valve with the speed controlled through the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Common Description
This energy unit is created exclusively for that medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as the velocity controlled from the adjustable needle valve. Once the lift rises to a substantial positoin, but the energy supply is minimize, the reducing motion is managed from the manual override function.
Power UNITS FOR LIFT TABLE 3
Standard Description
This power unit is created exclusively to the massive lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve plus the velocity controlled by a stress compensated flow management valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This electrical power unit is built solely for that large lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve plus the velocity managed by the adjustable needle valve. When the lift rises to a large positoin, but the power supply is reduce, the decreasing motion is managed from the manual override function.
Unique Notes
one. This energy unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic parts concerned just before set up of the power unit.
3. Viscosity of your oil shoud be 15~46 cst,which should also be clean and totally free of impurities.N46 hydraulic oil is encouraged.
4. Oil shifting is required soon after the initial one hundred operation hrs,afterwards after every 3000 hrs.
5. The electrical power unit shown is designed to be mounted vertically.