C Kind Flex-Flex Couplings
The C Kind coupling consists of two flex hubs, one sleeve and a single accessory kit consisting of seals and snap rings.
CFR Kind Flex-Rigid Couplings
The CFR Form coupling include 1 flex hub, one rigid hub, a single sleeve, 1 accessory kit consisting of seals and snap rings.
Basic and cheap sort of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Available as vertical and horizontal couplings
Broad number of exclusive variations such as full-flex, flex-rigid mill motor
Normal configurations can be found from the shelf
Ordering Information
Application: Driver and Driven.
Type and dimension of coupling, horizontal, vertical and so on.
Energy: Motor horspower or torque requirement.
Pace: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Shaft sizes.
C and CFR Style Couplings
Ordering Details
Puller Holes are conventional on sizes four as a result of 12.
Puller Holes are available for sizes 7/8 by means of three.five at an additional charge.
The BSE (distance In between Shaft Ends) might fluctuate between G and G1.
Interference bores without any set screws are typical unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, consult Engineering Part.
Bigger sizes can be found, please check with Technical Assistance.